Can Am Spyder Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Turned on the unit, ABS fault came on the scree. Plugged into BUDS system and it showed code C0044 - which is brake pressure sensor failure or BLS failsure (brake light sensor). When hooked to buds, low pressure sensor light on the computer works as it should. Have tested the connectors and it reads as it should. The issue finding is the brake pressure (psi) is supposed to read 3500 kpa or 508 psi - it is reading 2850 psi (maxed out) bleeding doesn't change anything. Changed the brake pressure switch (example one click / two clicks) and it works as it should. The light will come on after when you press the brake pedal down - once you release it will suddenly come on. We have tried bleeding the brakes, the fuses are fine, changing the whole switch does nothing, the wires are intact. Not sure what the next step is. Tested the HCM and that came up fine as well.
Thanks
2011 Spyder SM5
 
1 - 1 of 1 Posts
Top