Can Am Spyder Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I am confused when checking oil in the Spyder.

My unit has 11 100 kms and last oil change was at 7000 km. I checked the oil in the garage on level surface, the bike was cold. I noticed that there was no oil reading on dipstick. I started it and let it run for about 10 mins, checked again and same result, or barely reading on the dipstick. I added about 500ml or so of synthetic oil, checked again, and all looked fine.

After going for a ride about 30 km or so, I checked it when I got home and it was way passed the full mark. I am quite confused.

Today, I checked it cold, and again was barely registering on the dipstick. After reading the manual and talking with neighbor who has owned motorcycles all his life, we checked it again. We started the bike and let it run for a good 10 or 15 mins, until the heat gage recorded about 3 bars, which is about operating condition. We checked the dipstick and it was just a tad below the full mark.

My question is, how do you check the oil level in your Spyder to get an accurate reading. What do you recommend?

Hoping to get good feedback from the Spyder family.
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #6 ·
Thanks.

This is a weird system. The Spyder has been parked for about 3 hours now from a 15 km ride from work and is now marking full on dipstick.

When you check it cold, from what I understand is that it has been sitting for a day or so. I am just afraid to add too much oil. Do you ever add oil to yours in between oil changes? I will check it again tomorrow morning before I leave for work.

Yes checking oil level is a pain in the arse compared to 2 wheel motorcycles.

I used to do it according to owners manual. Remove left middle side panel. Engine must be at normal operation temp (3 bars). start bike and idle for 30 seconds. Shut bike off check oil-should be just below full mark.

I now, not recommended for others, check when stone cold. Oil should just touch end of stick.
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #7 ·
The procedure to checking the oil is in the owners manual. As I recall, you should check it after it is fully warmed up. 3 bars +, like after a ride. Shut off the engine, pull the panel and start it for 30 seconds. Shut it off and check it immediately. Make sure you screw in the dipstick immediately. If you check it cold, you will not get a reading on the dipstick.
Dick
THanks for the tips. I will check it after my next ride and make sure it is at 3 bars or so.

I am sure that a lot of people are adding more oil than needed, now that can't be too good for the engine.
 
1 - 3 of 3 Posts
Top