HELP VSS and ABS Limp mode problem - Spyder TechTalk - can-am Spyder Forums -

Jump to content


HELP VSS and ABS Limp mode problem

  • Please log in to reply
1 reply to this topic

#1 Ted in ncal

Ted in ncal


  • Members
  • 6 posts
  • Your Ride:2014 RT limited

Posted 25 December 2014 - 03:45 PM

I recently replaced the rear tire on my 2014 Spyder RT LTD.

When starting the bike a warning appeared on the screen. It showed the VSS and ABS symbols. I removed the ABS sensor and cleaned it's face and made certain that all of the shims were in place. Replaced the sensor and the screen displayed the same warnings.

I have both ( 2013 and 2014 ) manuals and so far have not found anything that helps. Is there something to cancel the warnings?

#2 ingramsail



  • Members
  • 3 posts
  • Your Ride:2014 RTS SE6

Posted 26 December 2014 - 11:35 AM

Have you set the brakes and checked to see if one pad is not releasing. The screen should reset after you shutdown and pull key, then retry. If you need more or better help try Spyderlovers .com.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users