[Tuan Vu]

Hi, I have one 2008 Spyder in Vietnam. And there's no dealer here. My bike is in limp mode now with "Vss fault, check engine, check dps" message, I check the codes and it shows "P0520, C1183, C0051". All about oil pressure sensor and Steering Angle Sensor (SAS). I've disconnected and reconnected all the sensor, opened & cleaned the SAS but problem is not solved.

So now, can I disable SAS for the bike to quit limp home mode? Cause there's no BRP dealer here, and I dont have BUDS & cable to reset, initialize the SAS as the service manual says.

Thanks!
Reply With Quote

[Tuan Vu]

anyone can help me? now the spyder is useless! I can pay for the instruction. Thanks!

This post has been edited by Tuan Vu: 26 May 2011 - 10:56 PM

[RattiganRoger]

Tuan Vu, on 26 May 2011 - 10:55 PM, said:

anyone can help me? now the spyder is useless! I can pay for the instruction. Thanks!

Sorry, but without B.U.D.S you are, IMHO stuck.

[rrman01]

mate when mine went to limp mod i pulled all fuses out and waited 30min put em back in and turned on bike still limp mode then took my spare key which i had to get from home 1hour all up to get key put it in and codes were gone then other time put on dyno to tune hit brake boom limp mode done the same as b4 didnt work 3hrs later got on bike to ride hom limp mode still on then rode home 5min turn bike off pull key out waited 30min key in and boom limp mode gone so may be u didnt have to do all that u did just take key out and wait anyway good luck with it take back to where you got the bike from or insure it and